Control Data Cyber 170 Series Operator's Manual page 89

Command
TRANEX.
n. STOP.
Response
This option causes the system to
check all working files for the proper
length. This option should be used
only when it is suspected that inform-
ation on mass storage has been
destroyed, and is activated auto-
matically when TELEX aborts. If
the operator thinks that mass storage
is intact, this switch can be dis-
abled (1. OFFSW4. ).
1.
ONSW5. Call DMP, which dumps information
to the OUTPUT file after TELEX is
dropped or aborted. This option
provides a listing which may assist
an analyst in determining the pro-
blem that existed when TELEX
dropped or aborted. This sense
switch is set by default when TELEX
is activated.
1. ONSW6. Release OUTPUT file containing
dump information written after
TELEX is dropped or aborted (refer
to
1.
ONSW5. option) immediately
after the dump is taken. When sense
switch 6 is not set, the OUTPUT file
is not released until TELEX is
terminated.
It
is then printed with
the TE LEX dayfile.
This switch applies only when sense
switch 5 is set.
Calls the TRANEX subsystem to control point 2. This
command is not valid if a job currently ass igned to
control point 2 has a queue prior ity greater than MXPS.
For complete information concerning the TRANEX
subsystem, refer to the TRANEX Operator's Guide
Addendum.
Drqps (terminates) subsystem currently assigned to
control point n. This command must also be entered
in order to drop any job with a queue priority greater
than MXPS.
Refer to the System Control Commands, ENABLE, DISABLE, AUTO, and MAINTENANCE,
for additional information concerning subsystem control.
60435600 A
3-33