Control Data Cyber 170 Series Operator's Manual page 232

t:d
I
~
~
m
o
H::..
C..I3
01
m
o
o
~
Message
RECOVERY IMPOSSIBLE LENGTH OF DEVICES
TRT BAD.
RECOVERY IN PROGRESS.
REQUEST xxxxxxx, eq
REQUEST DISPLAY. (xxx).
REQUEST *K* DISPLAY.
REQUESTED FILE NOT AVAILABLE.
RESEX FAILURE.
Routine
RMS
(operator message)
TELEX2
(dayfile message)
LFM
(operator message)
DIS,026
(operator message)
PF utilities,
MSI, STAGE,
MODVAL, PROFILE
(operator message)
PFU
(dayfile message)
PFM
(error log message)
Description Action
Reading track reservation table (TilT) into central memory If error occurred during level
from mass storage during level
0,
1, or 2 deadstart was 1 or level 2 recovery deadstart,
unsuccessful. perform level 0 (Initial) dead-
start. I
If error occurred during level
o
deadstart, enter GO to initial-
ize device with parameters de-
fined in label; permanent files
on device are lost.
Informative message indicating that TELEX has begun None.
recovery procedures due to an abort or termination condition.
Job is requesting that equipment type eq be assigned to file Assign equipment to control
xxxxxxx.
point.
Program (xxx) Is waiting for the display to be assigned.
Enter DSD command:
This message appears in the comment field of the control n. ASSIG N, xx. .
point at which the program is active on the job status
n Control point num-
(B) display.
ber requesting as-
xxx
026 File editor signment
DIS Job display routine xx EST ordinal of the
name
Program name
display console
The K display is requested at the specified control point. Enter command K, n.
This message appears in the comment field of a control
n Control point num-
pOint on the job status (B) display.
ber
Entry for file requested was not found in the FNT (file name
Inform site analyst.
table).
The resource executive (RESEX) has encountered a fatal
Inform site analyst.
error.
I
I
I
- - - - - - - - - - -