Assembly; Mounting The Lower Handle; Mounting The Upper Handle - FLORABEST FRMA 36 / 2 B1 Translation Of The Original Instructions

GB

Assembly

• Only carry out work that you know you
are capable of.
• If in doubt, consult an expert or our
service centre directly.

Mounting the lower handle

1. Attach one end of the lower han-
dle (3) to the screw thread on
the apparatus housing.
2. Pull the ends of the lower handle
(3) slightly apart and put the
other end of the screw thread on
the apparatus housing.
The lug indicating the angular
position (3a) must face inwards.
You can lock the lower
handle in 3 angular posi-
tions (steep/medium/shal-
low).
3. Place the enclosed washers (6a)
in position. The curved sides
face the handle.
4. Turn the lower tightening levers
(6) clockwise.
5. Lock the tightening levers (6) by
pressing them in the direction of
the lower handle (3). The tighten-
ing levers must be pulled tight
and then positioned against the
handle so that tightening can be
carried out with medium force.
If this fails, continue to turn the
tightening lever clockwise, or
loosen it by turning anti-clock-
wise (see small image).
1 4

Mounting the upper handle

1. Fasten the upper handle (1) with
the enclosed screws (2b), the
washers (2a) and the upper tight-
ening levers (2) on the right and
left of the lower handle (3). The
release button (17) must be lo-
cated on the right in the mowing
direction.
Two positions are possible.
2. Turn the tightening levers (2)
clockwise.
3. Lock the tightening levers (2) by
pressing them in the direction of
the handle (3). The tightening
levers must be positioned against
the handle such that tightening
can be carried out with medium
force.
If this fails, continue to turn the
tightening lever clockwise, or
loosen it by turning anti-clockwise
(see small image).
4. Clipping in the cable holders:
Clip in the cable holders (15) on
the upper (1) and lower handle
(3) and use them to fix the device
cable (16) in position. At the end
of the bottom handle (3) you can
insert the device cable (16) into
an existing cable holder.
Release the tightening lever (2+6)
and fold the bow-type handle (1)
and the lower handle (3) together so
that the device takes up less space.
Make sure not to pinch the machine
cables while doing this.