RUGGEDCOM RS900F
Installation Guide
Section 1.5.1
Supported Fiber Optic Cables
The following fiber optic cable types are supported under the stated conditions.
Cable Type
OM1 (62.5/125)
OM2 (50/125)
a
OM3 (50/125)
a
OM4 (50/125)
a
Laser optimized.
Section 1.6
Tamper-Evident Security Seals
In compliance with the security requirements of the Federal Information Processing Standards (FIPS140-2), FIPS-
compliant tamper-evident security seals are applied to potential access points on this device. Security seals provide
evidence of unauthorized tampering or removal of components.
IMPORTANT!
Worn, damaged or missing seals must be replaced immediately.
Replacement seals are available for purchase from Siemens. For more information, contact a Siemens
Sales representative.
There are three ways to determine if a security seal has been tampered with:
• The seal is cut or torn
• A pattern is left on the device when the top layer of the seal is removed
• Residue left by the seal is visible on the device under ultra-violet light
For information about the placement of security seals, refer to the
Security Policy
[https://support.industry.siemens.com/cs/ww/en/view/109757984].
Supported Fiber Optic Cables
Modal Bandwidth
Wavelength (nm)
(MHz·km)
850
1300
850
1300
850
1300
850
1300
100Base-FX
200
—
500
2000
500
—
500
2000
1500
—
500
2000
3500
—
500
2000
RUGGEDCOM ROS-F FIPS 140-2 Non-Proprietary
Introduction
Distance (m)
1000Base-SX
10GBase-SR
275
33
—
—
550
82
—
—
550
300
—
—
550
400
—
—
Chapter 1
5