Siemens RUGGEDCOM RS900F Installation Manual page 27

RUGGEDCOM RS900F
Installation Guide
Figure 9: Terminal Block Wiring – Dual DC Power Supply Inputs
1. Positive Terminal 2. Negative Terminal 3. Surge Ground Terminal 4. Braided Ground Cable
5. Using a braided wire or other appropriate grounding wire, connect the surge ground terminal to the chassis
ground connection. The surge ground terminal is used as the ground conductor for all surge and transient
suppression circuitry internal to the unit.
6. Connect the ground wire from the power source to the chassis groun terminal on the terminal block.
Connecting Low DC Power
2 2
1 3 1
4
± ±
± ±
Chapter 2
Installing the Device
17