Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for FAAC 595
Summary of Contents for FAAC 595
-
Page 2: Table Of Contents
INDEX CE DECLARATION OF CONFORMITY .......................... 2 IMPORTANT NOTICE FOR THE INSTALLER ........................2 DESCRIPTION AND TECHNICAL CHARACTERISTICS ....................3 . MAXIMUM USE CURVE ............................. 3 2 INSTALLATION LAYOUT ............................4 3 DIMENSIONS ................................ 4 4 INSTALLATION ............................... 4 4. PRELIMINARY CHECKS ............................. -
Page 3: Ce Declaration Of Conformity
17) Each installation must be fitted with at least one flashing light forth will affect the reliability of the product and/or could be (e.g. FAAC LAMP , MINILAMP etc.) as well as a warning plate source of hazard. suitably fixed to the gate, besides the safety devices as per point “16”... -
Page 4: Description And Technical Characteristics
595 I/S AUTOMATED SYSTEM The 595 I/S automated system is a hydraulic unit formed of a Table 1 Technical specifications of 595 I operator motor pump and a piston-rack assembly, which ensures optimal Power supply 230V (+6 -10 %) 50Hz automation of up-and-over garage doors for residential and condo applications. -
Page 5: Installation Layout
T10 key-operated pushbutton g Tx photocell Fig.C DIMENSIONS 4.2 INSTALLATION OF OPERATOR Accessories of the FAAC 595 I/S operators are supplied in two versions: Welded assembly - welded telescopic arms, drive shafts, and mounting brackets. Screw assembly - all accessories feature screw-on attachment. -
Page 6: Positioning The Back Plate / Operator /Drive Shafts
Fig. 6 Fig.7 Respect maximum door dimensions as per the technical specifications and install either one operator (FAAC 595) at the centre of the door (fig.8) or two operators at the sides of the door (595 I and 595 S), fig.9. -
Page 7: Adjusting The Counterweights
4.6. DOUBLE APPLICATION For up-and-over doors 3.50 to 5 m wide, one 595 I (integrated) operator and one 595 S (slave) operator must be used. The maximum permitted height is 3 m. Install in the same way as for a single motor (fig. -
Page 8: Manual Operation
The limit switch kit makes it possible to stop the door in two specific positions. It can be fitted on the FAAC 595 I operator only if a control board has been installed on it for this function. When this requirement has been met, proceed as follows, referring to fig. -
Page 9: Maintenance
Activate the operator electrically so that it turns to the end of its travel in both directions of rotation. Repeat this operation several times if necessary. Follow the installation instructions to reassemble. 9. REPAIRS For repairs, contact an authorised FAAC Service Centre. - Page 10 The 595 I/S automated system is fitted as standard with an However, some simple rules should be followed to avoid anti-crushing safety device that limits the torque transmitted to accidents: the door.
- Page 12 Les descriptions et les illustrations du présent manuel sont fournies à titre indicatif. FAAC se réserve le droit d’apporter à tout moment les modifications qu’elle jugera utiles sur ce produit tout en conservant les caractéristiques essentielles, sans devoir pour autant mettre à...