Table 2 Programming Page Functions - finmon mi64 User Manual

When adding these roles or functions, you will need to use the 'programming
pages' which are accessed using the corresponding P key. For example, Page 2
is accessed by selecting [P2]. See below:

Table 2 Programming Page Functions

Page Function
1 Assigning
partitions
2 Assigning
user type
3 Add remote
functionality
4 View the user
number
You will also have to select a user type. See below for the options:
Table 3 User Type Values
Values User Type
1 Master
2 Duress
3 Arm to
Disarm
4 Global
Arm/Disarm
5 Reporting
Description
Select the partition number followed by [*] to add
or remove partitions to and from a user's profile.
Only partitions belonging to the profile of the
master code used to access programming mode may
be added or removed.
Touch the user type number followed by [*] to
enable and disable the options as per the user type
table below.
Touch any button on an unused remote in order to
enrol it to this user. Only 1 remote may be assigned
per user code and only one user may be assigned to
a remote.
The user number is displayed in binary format.
Description
Can add/remove and edit user codes
A duress code will disarm the panel normally and a
duress signal will be sent to the alarm monitoring
company. This signals that a user has been forced to
disarm the panel under duress.
This code will only disarm a partition if the same
Arm to Disarm code was used to arm. This code
may be given to a user whom has limited access to
the premises.
A Global code will simultaneously arm and disarm
all partitions in a users profile. All partitions will
follow the status of the partition which was selected
at the time the code was entered.
The user code will report an open and a close when
arming and disarming.