finmon mi64 User Manual page 21

Step-by-step
Note
10.2 User Set Up and Assigning Remotes
As mentioned, by default any user codes you create will be assigned to all
partitions and will be Normal Users. You can edit this during the user code
creation, or can come back and assign/change settings later.
Mi64 2017
 Enter the [USER CODE].
 Touch [*].

Touch the [Alt] key followed by the [*] key.
 The partition status indicators will flash as follows:
P1-orange, P2-green, P3-green, P4-orange.
 Enter a Master User code followed by the [*] key.
The keypad will beep and the partition status
indicators will flash- green, orange, orange, green.
 Select an option from the User Option table above
and then touch [*].
 For the Add, Edit or Delete code options (option
values 1,2 and 3) enter the relevant user code and
touch the [*] key.
 For Delete by user number option (option value 4)
enter the user code number and touch the [*] key.
 In Delete modes (option 3 and 4) codes or users may
be deleted sequentially. After deleting a code/user
enter a star followed by another user or code
followed by a [*] etc. alternately enter a [#] to exit
the mode.
 The Keypad will sound a long beep to indicate the
change has been accepted.
 If two short beeps sound, a mistake has been made.
Touch [#] to clear your entry and try again.
Keep an updated list of all users and their user codes.
If you want to edit by user number- this is the sequential
number that they were added to the system. For example,
the third user code to be added, is user number 3.
By default all new user codes are assigned to all partitions
and are a normal user. If you change this, see User Setup
below.
21