Viewing The Partition Memory - finmon mi64 User Manual

Step-by-step
Note

8 Viewing the partition memory

When
How
Step by Step
Mi64 2017
 Enter via an assigned entry door. Any other entry
point will cause an alarm.
 As you enter via the entry zone, the entry delay will
start counting down and your keypad will beep.
 Touch the [#] key to wake up the system and clear
any unintended entries.
 Enter a valid [USER CODE] during the entry delay
time period.
 If a correct code is entered, the system will disarm.
 If you have entered an incorrect code, the keypad
will beep. Touch [#] and re-enter the correct code.
 If not valid user code is entered by the end of the
entry delay, the alarm will sound and your
monitoring company will be notified.
If you make a mistake when entering the code. Touch [#]
to clear your entry and start again.
If the alarm is sounding when you arrive, or the partition
indictor is flashing there has been a violation. There could
still be an intruder on the property. Do not enter and
call for assistance.
When an alarm is registered, the siren will sound, the
partition indicator will flash red, and the zone indicators
for the violated zones will be flashing. Once the alarm is
cancelled by entering a valid user code, the keypad will
return to its normal state.
If you want to look back and check which zones were
violated, you can do this via the partition memory.
Once you have disarmed the panel:
 Touch [ALT].
 Then [0].
 Disarm the system using a valid [USER CODE] for
the partition that caused the alarm.
 Touch [ALT].
 Touch [0]
 The zone indicators for the zones that were violated
17