Home Arming - finmon mi64 User Manual

When
How
Step-by-step
Note

5.3 Home Arming

The mi64 is designed to allow you to have two home profiles. This allows you
to arm the perimeter of your premises/home without arming the interior zones
that you will be active in.
For example, early evening you could activate Home1 profile which arms your
external doors and outside beams- but not any of the internal motion detectors.
Then when all go to bed, you could activate Home2 which could additionally
arm the internal motion detectors in rooms that you do not use such as the
lounge or kitchen.
5.3.1 To Home Arm
When
How
Mi64 2017
You are leaving the premises, and there is no one else on
site/at home. You do not want to system to record the user
who has armed the system.
 Hold down the relevant [P] key to arm that partition.
 Leave via your exit zone.
 Ensure the partition/s you want to arm are ready to
arm (illuminated green). If not check that all
monitored windows and doors are closed.
 Touch the [#] key to clear any key entries.
 Hold down the [P] key for the partition you want to
arm.
 The Keypad will beep and the P key will flash
orange for the duration of the entry/exit delay.
 You now should leave via the entry/exit route.
 The panel will arm at the end of the entry/exit delay,
and the keypad sound a long beep.
Depending on the type of user, they can only arm and
disarm partitions that they are assigned to.
If you do not violate the entry/exit zone during the
entry/exit delay- the panel will arm in Home1 mode.
You are at home or your business but want to arm the
perimeter, or an area you are not using.
 Hold down the relevant [HOME] key to arm the
13