Advertisement
Procedure
5
6
Note: Remove the cargo box or flatbed from the vehicle before installing this kit; refer to the Operator's Manual for the vehicle.
Note: For Non-TC models, install the High-Flow Hydraulic Kit before installing this kit; contact your Authorized Toro
Distributor about purchasing this kit.
1
Preparing the Machine
No Parts Required
Procedure
1. Move the machine to a level surface (A and B of
1).
2. Set the parking brake (C of
3. Shut off the engine (D of
4. Remove the key from the key switch (E of
Description
Male quick-connect coupler
Female quick-connect coupler
Hydraulic hose (3/8 x 61 inches)
Hydraulic hose (3/8 x 79 inches)
Cable tie
Tube-clamp half
Flange-head bolt (5/16 x 1-1/2 inches)
Rocker switch
Kit wire-harness adapter
Figure 1
Figure
1).
Figure
1).
Figure
Qty.
1
1
1
1
2
2
1
1
1
2
Preparing the Hydraulic Motor
Parts needed for this procedure:
1
Hydraulic motor
1
Shaft guard
Figure
1
Motor bracket
2
Flange-head bolt (1/2 x 1-1/2 inches)
2
Flange nut (1/2 inch)
1
Anti-rotation bracket
1
Flange-head bolt (5/16 x 3 inches)
1
Flat washer
2
Compression spring
1
Flange locknut (5/16 inch)
2
Straight hydraulic fitting (7/8 inch)
2
Hydraulic hose (1/2 x 17 inches)
2
Male coupler
Assembling the Brackets to the
Hydraulic Motor
1. Apply medium-duty thread-locking compound to the
threads of 2 flange-head bolts (1/2 x 1-1/2 inches).
1).
2. Install the shaft guard and the motor bracket onto the
hydraulic motor with 2 flange-head bolts (1/2 x 1-1/2
inches) and 2 flange nuts (1/2 inch) as shown in
2.
Note: Torque the bolts and nuts to 67 to 83 N∙m (91
to 113 ft-lb).
2
Use
Install the hydraulic hoses for the
boom-lift cylinders.
Install the rocker switch.
Figure
Advertisement
