Output Setting (D5301 To D5400) - YOKOGAWA UTAdvanced Series User Manual

6.4 UT55A/UT52A/UP55A D Registers

Output Setting (D5301 to D5400)

Register
No.
D5301 OT.H
D5302 OT.C
CT
D5303
CTc
D5304
D5305 to D5310
D5311 V.AT
D5312 V.RS
D5313 V.L
V.H
D5314
TR.T
D5315
D5316 V.MOD
D5317 to D5320
D5321 RTS
6-88
Description
Heating-side control output selection
Cooling-side control output selection
Control output cycle time
Heating-side control output cycle
time (in Heating/cooling control)
Cooling-side control output cycle
time
Automatic valve position adjustment
Valve position setting reset
Fully-closed valve position setting
Fully-opened valve position setting
Valve traveling time
Valve adjusting mode
Retransmission output type of RET
Range and meaning of value
0: OFF
1: OUT terminals (voltage pulse)
2: OUT terminals (current)
3: OUT terminals (relay)
4: OUT2 terminals (voltage pulse)
5: OUT2 terminals (current)
6: OUT2 terminals (relay)
When the UTAdvanced parameter is set by key stroke,
the heating-side control output selection, and cooling-side
control output selection comprise one parameter.
0.5 to 1000.0 s
0: OFF (Stop automatic adjustment)
1: ON (Start automatic adjustment)
0: OFF
1: ON (Resets the valve adjustment settings and causes
the indication "V.RS" to blink.)
Pressing the SET/ENTER key with valve position set
to the fully-closed position by Down arrow key causes
the adjusted value to be stored. When V.L adjustment is
complete, V.L stops blinking.
Pressing the SET/ENTER key with valve position set to
the fully-opened position by Up arrow key causes the
adjusted value to be stored. When V.H adjustment is
complete, V.H stops blinking.
5 to 300 s
0: Valve position feedback type
1: Valve position feedback type (moves to the estimating
type if a feedback input error or break occurs.)
2: Valve position estimating type
0: OFF (Disable)
1: PV1 (PV)
2: SP1 (SP)
3: OUT1 (OUT (Valve opening: 0 to 100 % in Position
proportional control))
4: LPS (15 V DC loop power supply)
5: PV2 (Loop-2 PV)
6: SP2 (Loop-2 SP)
7: OUT2 (Loop-2 OUT)
8: TSP1 (Target SP)
9: HOUT1 (Heating-side OUT)
10: COUT1 (Cooling-side OUT)
11: MV1 (Position proportional output (internal computed
value))
12: TSP2 (Loop-2 target SP)
13: HOUT2 (Loop-2 heating-side OUT)
14: COUT2 Loop-2 cooling-side OUT
15: MV2 (Loop-2 position proportional output (internal
computed value))
16: PV (PV terminals analog input)
17: RSP (RSP terminals analog input)
18: AIN2 (AIN2 terminals analog input)
19: ANI4 (AIN4 terminals analog input)
Loop-2 setting values are unavailable in Single-loop
control.
IM 05P07A01-01EN