Ricoh Aficio SP C210 Setup Manual page 7

! If toner or used toner is inhaled, gargle with plenty of water and move into a fresh air
environment. Consult a doctor if necessary.
! If your skin comes into contact with toner or used toner, wash the affected area
thoroughly with soap and water.
! If toner or used toner gets into your eyes, flush immediately with large amounts of
water. Consult a doctor if necessary.
! If toner or used toner is swallowed, dilute by drinking a large amount of water. Consult
a doctor if necessary.
! Keep toner (used or unused) and the toner bottle out of reach of children.
! Do not put an object on the right cover when it is open.
! Protect the equipment from dampness or wet weather, such as rain, snow, and so on.
! Before moving the machine, unplug the power cord from the wall outlet. If the cord is
unplugged abruptly, it could become damaged. Damaged plugs or cords can cause an
electrical or fire hazard.
! Grip the plug, not the cord, when pulling the plug from the socket. Pulling the cord
causes wear and tear that can result in fire or electric shock.
! Do not allow paper clips, staples, or other small metallic objects to fall inside the
equipment.
For environmental reasons, do not dispose of the equipment or expended supply
!
waste at household waste collection points. Disposal can take place at an authorized
dealer or at appropriate collection sites.
! The inside of this printer becomes very hot. Do not touch parts labelled "
(indicating a hot surface). Touching these parts will result in burns.
! The fusing unit becomes very hot. When installing a new fusing unit, turn off the
printer and wait at least an hour before replacing the old fusing unit. Not allowing the
unit to cool may result in burns.
! Do not pull out the fusing unit forcefully. It may cause the unit to fall and result in an
injury.
! When touching the fusing unit, do not touch any areas other than the handle as it may
cause a burn.
! When removing misfed paper, do not touch the fusing unit because it could be very
hot.
! To prevent an injury, this printer should be lifted by at least two people.
! The printer weighs about 29 kg (64 lb). When lifting the machine, use the inset grips
on both sides, and lift slowly. Otherwise the printer could break or cause injury if
dropped.
! Before installing options, the machine should be turned off and unplugged for at least
half an hour. Components inside the machine become very hot, and can cause a burn
if touched.
When lifting the paper feed unit, hold the bottom of it, and then lift it slowly. Lifting it
!
carelessly or dropping it may cause an injury.
! Do not touch the inside of the controller board compartment. It may cause a machine
malfunction or a burn.
CAUTION
Safety-3
"