Ricoh Aficio SP C210 Setup Manual page 6

! Do not handle the power cord or plug with wet hands. Doing so might cause an
electrical shock.
! Plug and unplug the power cable with dry hands, or an electric shock could
occur.
! Connect the power cord directly into a wall outlet and never use an extension
cord.
! Disconnect the power plug (by pulling the plug, not the cable) if the power
cable or plug becomes frayed or otherwise damaged.
! Confirm the wall outlet is near the machine and freely accessible, so that in the
event of emergency, it can be unplugged easily.
! Only connect the machine to the power source described in the manual.
! Avoid multi-wiring.
! Do not damage, break or make any modifications to the power cord.
! Do not place heavy objects on it, pull it hard or bend it more than necessary.
These actions could cause an electric shock or fire.
! To avoid hazardous electric shock or laser radiation exposure, do not remove
any covers or screws other than those specified in this manual.
! Turn off the power and disconnect the power plug (by pulling the plug, not the
cable) if any of the following conditions exists:
You spill something into the equipment.
!
! You suspect that your equipment needs service or repair.
!
Your equipment's cover has been damaged.
!
Do not incinerate spilled toner or used toner. Toner dust is flammable and
might ignite when exposed to an open flame.
Disposal should take place at an authorized dealer or an appropriate collection
!
site. If you dispose of the used toner containers yourself, dispose of them
according to local regulations.
! Dispose of the used toner cartridge in accordance with the local regulation.
! Do not take apart or attempt any modifications to this machine. There is a risk
of fire, electric shock, explosion or loss of sight. If the machine has laser
systems, there is a risk of serious eye damage.
! If you dispose of the used toner cartridges yourself, dispose of them according
to local regulations.
Do not remove any covers or screws other than those specified in this manual.
!
Some parts of the machine are at a high voltage and could give you an electric
shock. Also, if the machine has laser systems, direct (or indirect) reflected eye
contact with the laser beam may cause serious eye damage. When the machine
needs to be checked, adjusted, or repaired, contact your service representative.
! Keep the machine away from flammable liquids, gases, and aerosols. A fire or
an electric shock might occur.
! The supplied power cord is for use with this equipment only. Do not use with
other appliances. Doing so may result in fire, electric shock, or injury.
WARNING
Safety-2