Table of Contents
Advertisement
C099-F9P - User guide
https://www.u-blox.com/en/product/odin-w2-series
The software upload procedure consists of two consecutive phases. Firstly, a bootloader is required
to be uploaded:
.\stm32flash.exe -b 115200 -w <ODIN-W2-BOOT.bin> -S 0x8000000 COM<port number>
After a succesful bootloader upload, the actual
u-connectXpress
software shall be uploaded while
incrementing the memory index as shown below
.\stm32flash.exe -b 115200 -w <ODIN-W26X-SW.bin> -S 0x8010000 COM<port number>
Instructions of connectivity configurations of ODIN-W2 running the
u-connectXpress
SW are
available in C099-F9P User guide [5].
Figure 36: Power shell capture of bootloader upload
Figure 37: Power shell capture of u-connectXpresssoftware upload
UBX-18063024 - R11
Firmware update
Page 30 of 41
Advertisement
Table of Contents
