Blade Replacement; Return To Cembre For Overhaul - Cembre B-TC500 Operation And Maintenance Manual

4. BLADE REPLACEMENT

When changing blades, the battery must rst be removed from the tool.
After extended use, the blades may lose their cutting edge. Replace the blades as follows:
Lower blade
– Release latch (4) and open the tool head.
– Operate tool to advance the lower blade (3) until holding screw (18) is visible on the ram (12),
than remove the battery from the tool.
– Using a at blade screwdriver remove the holding screw (18) and release the lower blade (3)
– Insert the new blade and t the holding screw.
Before closing the tool head, release the oil pressure and retract the lower blade, otherwise
the tool head assembly may hit and damage the lower blade.
Upper blade
– Release latch (4) and open the tool head.
– Remove the circlip (18) and extract the head pivot (14), enough to release the tool head assembly.
– Remove circlip (22) and pivot pin (21), to release the latch (4).
Remove latch spring (17) from the upper blade (16).
– Unscrew the 4 screws (20) and remove the left hand guide (15) and the right hand guide (16) to
release the blade (2).
– Fit the left and right hand guides to the new blade, place the spring (17) into its seat and re- t
the latch (4).
– Fit the blade assemble to the head (19), fully insert the pivot (14) and secure with the circlip (18).

5. RETURN TO Cembre FOR OVERHAUL

In the case of a breakdown, contact your local Agent who will advise you on the problem and give
you the necessary instructions on how to dispatch the tool to our nearest service Centre; if possible,
attach a copy of the Cembre Test Certi cate supplied with the tool or, if no other references are
available, indicate the approximate purchase date and the tool serial number.
– Following information applies in member states of the European Union:
USER INFORMATION in accordance with "Directives 2002/95/EC and 2002/96/EC.
The 'Not in the bin' symbol above when shown on equipment or packaging means that the
equipment must, at the end of its life, be disposed of separately from other waste.
The separate waste collection of such equipment is organised and managed by the manufacturer.
Users wishing to dispose of such equipment must contact the manufacturer and follow the prescri-
bed guidelines for its separate collection. Appropriate waste separation, collection, environmentally
compatible treatment and disposal is intended to reduce harmful environmental e ects and pro-
mote the reuse and recycling of materials contained in the equipment. Unlawful disposal of such
equipment will be subject to the application of administrative sanctions provided by current legi-
slation.
9
(Ref. to Fig. 4)