Scv2000/Scv2020 Storage System Drives - Dell EMC SCv2000 Owner's Manual

Item Control/Feature
13 Serial port (3.5 mm mini jack)
14 Four Mini-SAS High Density
(HD) ports (Slot 1/Port 1, Slot 1/
Port 2, Slot 1/Port 3, and Slot 1/
Port 4)
15 Mini-SAS port B (Slot 2/Port 2)
16 Mini-SAS port A (Slot 2/Port 1)

SCv2000/SCv2020 Storage System Drives

The SCv2000/SCv2020 storage system supports only Dell Enterprise hard disk drives (HDDs) and Dell Enterprise solid-state drives
(eSSDs).
The drives in the SCv2000 storage system are installed horizontally. The drives in the SCv2020 storage system are installed vertically. The
indicators on the drives provide status and activity information.
Figure 8. SCv2000/SCv2020 Storage System Drive Indicators
Item Control/Feature
1 Drive activity indicator
2 Drive status indicator
14 About the SCv2000/SCv2020 Storage System
Icon Description
• Green LEDs 4–7 – High byte hex POST code
Not for customer use
— Front-end connectivity ports
NOTE: The mini-SAS HD ports are used for front-end connectivity only
and cannot be used for back-end expansion.
Back-end expansion port B
Back-end expansion port A
Indicator Code
• Blinking green – Drive activity
• Steady green – Drive is detected and has no faults
• Off – Normal operation
• Blinking amber (on 1 sec. / off 1 sec.) – Drive identification is enabled
• Blinking amber (on 2 sec. / off 1 sec.) – Hardware/firmware fault
• Steady amber – Drive is safe to remove