Mount In The Dashboard - Philips CID3693/00 User Manual

2
Stick the other end of the GPS antenna to
a metal surface of the car.

Mount in the dashboard

Note
•
Check wire connections before you mount the
main unit into a car.
•
If preset radio stations are lost when the
ignition key is turned OFF and then back ON,
reconnect the red leads crosswise to the
yellow ones.
1
If the car does not have an on-board
drive or navigation computer, disconnect
the negative terminal of the car battery.
• If you disconnect the car battery in
a car that has an on-board drive or
navigation computer, the computer
may lost its memory.
• If the car battery is not disconnected,
to avoid short-circuit, ensure that
bare wires do not touch each other.
2
Ensure that the horizontal slant of the car
dashboard opening is between 0 and 20
degrees. The unit cannot be used if the
dashboard opening's slant angle is above
20 degrees.
3
Fix the plastic clips and base support
(removed from the original in-car system)
to the main unit.
4
Fix the mounting brackets (removed from
the original in-car system) to the left and
right side panels of the main unit.
5
Fix the exhaust outlets of the original air-
conditioner to the two openings.
EN 11