Contents 1 Important Safety Notice 2 Your in-car entertainment system Introduction What’s in the box Overview of the main unit 3 Get started Install the car audio Turn on Set date and time 4 Use map Upgrade the map 5 Listen to radio Tune to a radio station Store radio stations in memory Tune to a preset station...
Notice Any changes or modiﬁcations made to this device that are not expressly approved by Philips Consumer Lifestyle may void the user’s authority to operate the equipment. Environmental information All unnecessary packaging has been omitted. We have tried to make the packaging easy to...
DivX ® The Bluetooth word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Philips is under license. Manufactured under license from Dolby Laboratories. “Dolby” and the double-D symbol are trademarks of Dolby Laboratories.
2 Your in-car entertainment system Congratulations on your purchase, and welcome to Philips! To fully beneﬁt from the support that Philips offers, register your product at www.philips.com/welcome. Introduction With the car entertainment system, you can: • quickly ﬁnd routine through the navigation system •...
Overview of the main unit a Disc slot b DISP/ / • Adjust screen brightness. • Turn on/off the screen display. c AV IN/ • Open the cover and connect the AV IN/USB device. /MAP • Open the cover and insert/remove the SDHC/GPS map card.
These instructions are for a typical installation. However, if your car has different requirements, make the corresponding adjustment. If you have any questions regarding installation kits, consult your Philips car audio dealer. Caution • This unit is designed for negative ground (earth) 12 V DC operation only.
Check the car’s wirings carefully, then connect them to the unit. Yellow Green Blue Gearbox Connect GPS antenna To receive signal from satellites, connect the supplied GPS antenna to your car and the system. Connect the supplier GPS antenna to the system ﬁrst.
Mount in the dashboard Note • Check wire connections before you mount the unit into a car. • If preset radio stations are lost when the ignition key is turned OFF and then back ON, reconnect the red leads crosswise to the yellow ones.
Reconnect the negative terminal of the car battery. Turn on Caution • Risk of road accidents! Never watch video or adjust settings while you drive. Press and hold /MUTE/VOL to turn on the unit. » The available OSD (On-Screen Display) languages are displayed. Tap a language to select.
Set time Tap [Time]. Tap on the displayed time. » A submenu is displayed. to set hour and minute. • When date/time is set, tap tap to return to main menu. 4 Use map • You may need to upgrade the map (sold separately) before using it (see “Upgrade the map”...
Insert the upgraded map card back into the map card slot. Turn on the car audio. » The map upgrades in a few minutes. 5 Listen to radio Tune to a radio station to display home menu. Tap [Radio]. » Band and frequency information is displayed.
Tap [Goto]. Tap the numbers to enter frequency. • to clear the last entered number. • to clear all the entered numbers. to conﬁrm. » The radio station is broadcast. Select radio range Before you start to search for radio stations, you can select radio range.
Select program type Before tuning to RDS stations, you can select program type and let the unit search only for programs of the selected category. Tap FM band to select FM1, FM2, or FM3. Tap [PTY] . » List of available program type is displayed.
[TA] (Trafﬁc If you do not want to miss Announcement) trafﬁc announcement during enjoying music, you can turn on the [TA] function. When there is trafﬁc announcement, the unit switches to tuner mode (regardless of the current mode) and begins to broadcast the announcement on trafﬁc conditions.
6 Play Load discs You can play video, audio or images stored on the following discs: • DVD video, DVD-R, DVD-RW • • Audio CD, CD-R, CD-RW Note • Ensure that the disc contains playable content. Insert a disc into the disc slot with the label side facing up.
Remove the USB device. Insert USB or SD/MMC card Note • Ensure that the device contains playable content. • The unit supports SDHC card. Open the AV-IN/USB/SD/MAP socket cover. Insert the SD/MMC card into the SD/ MMC card slot. » Play starts automatically.
Search within a title/folder Direct search Tap anywhere except for the upper left corner to display menu on the screen, if necessary. Tap . » The search screen is displayed. » For video ﬁles, tap Tap the numbers to enter chapter/ﬁle number, then tap •...
• [Repeat A-]: the start of the section to repeat. • [Repeat A-B]: the end of the section to repeat. • The selected section plays repeatedly. To exit A-B repeat mode, tap repeatedly until [Repeat A-B off] is displayed. Random play You can play audio tracks/ﬁles in random order.
Select slide show duration Tap anywhere except for the upper left corner to display menu on the screen, if necessary. repeatedly to select: • Fast: 3 seconds • Normal: 5 seconds • Slow: 8 seconds 7 Play with Bluetooth device You can make or receive phone calls with Bluetooth-enabled phones through the unit.
Disconnect Bluetooth devices To disconnect one device, tap » (green) is displayed. • The device will also be disconnected when the device is moved beyond the operational range. • If you want to reconnect the device to the unit, place it within the operational range. •...
During talking, tap » The voice is transferred from the unit’s loudspeaker to the mobile phone. Listen to music from Bluetooth device If the connected Bluetooth device supports Advanced Audio Distribution Proﬁle (A2DP), you can listen to the music stored on the device through the unit.
8 Adjust sound Adjust volume Turn /MUTE/VOL button clockwise to increase volume. Turn /MUTE/VOL button anti-clockwise to reduce volume. Mute During play, press /MUTE/VOL. • To restore the sound, press MUTE/VOL again. • You can also tap on the screen to turn off sound.
Tap F, R, L, or R to adjust fader/balance value. • [Fade] fader range: +24 to -24. (F = front speaker, R = rear speaker) • [Balance] balance range: -24 to +24. (L = left speaker, R = right speaker) to exit.
to highlight a setting. Tap on the option to display/select an option. General Options Description settings [Radio [USA], [S. Select one that region] Amer-1], matches your [Arabia], location. [China],[S. Amer-2], [Europe], [Korea], [OIRT] [Radio [Local] Only stations with range] strong signals can be broadcast.
to exit. Adjust video settings Tap [Video]. Tap an option repeatedly to select: Video Options Description settings [Aspect [Full] For widescreen display. ratio] [Normal] For normal display. [Video [Auto] The correct format is input] set automatically. Select this option if you are not sure which format should be selected.
[Pairing View code for code] pairing the unit with other Bluetooth devices. to exit. Adjust language settings Tap [Language]. Tap an option repeatedly to select: Language Options Description settings [OSD] [English] Select on-screen- display language. Español Português [DVD [English] Select DVD audio audio] language.
Adjust DVD rating Tap [DVD rating]. Tap an option repeatedly to select: DVD rating Options Description [Set Set password to password] restrict the play of discs. The default password is 0000. [Rating [Kid Acceptable for level] safe] children. Acceptable for general viewers.
Buy a fuse that matches the voltage of the damaged fuse (15A) Replace the fuse. Note • If the fuse gets damaged immediately after it has been replaced, there may be an internal malfunction. In such case, consult your Philips dealer.
11 Product information Note • Product information is subject to change without prior notice. General Power supply 12 V DC (11 V - 16 V), negative ground Fuse 15 A Suitable speaker 4 - 8 impedance Maximum power 50 W x 4 channels output Continuous power 24 W x 4 channels...
If you encounter problems when using this apparatus, check the following points before requesting service. If the problem remains unsolved, go to the Philips web site (www. philips.com/welcome). When you contact Philips, ensure that the apparatus is nearby and the model number and serial number are available.
Image ﬂashes or distorted • Video DVD settings do not match with the DVD. Adjust video DVD settings. • Video connection is improper. Check the connections. Noise in broadcasts. • Signals are too weak. Select other stations with stronger signals. •...
13 Glossary Bite rate The max data transfer through the USB port. Bluetooth ® Bluetooth is a short-rang wireless protocol that is meant to allow mobile devices to share information and applications without the worry of cables or interface incompatibilities. The name refers to a Viking King who uniﬁed Denmark.