About The Gps Antenna; Mount Into The Dashboard - Philips CED1900 User Manual

Hide thumbs Also See for CED1900:
Table of Contents

Advertisement

About the GPS antenna

Warning
Risk of injury: Never install the antenna and its
accessories on the airbag cover.
Risk of swallowing parts: Keep the antenna and
accessories out of the reach of children.
Caution
Risk of electromagnetic interference: Do not install the
GPS antenna over any sensors or vents.
Risk of short circuit, malfunction, or damage to your car
navigation system: Do not alter the GPS antenna cable
or dismantle the antenna box.
Risk of poor reception: Use the supplied metal sheet
only, and never cut or distort it; do not paint the GPS
antenna.
Risk of damage to the GPS antenna cable: Never pull
the antenna cable when you remove the antenna.
Risk of scratching your car: The GPS antenna box has
a magnet. When you install or remove it, do not drag it
on any metal surface.
Connect the GPS antenna
a
GPS AERIAL
1
Connect the GPS antenna to your car
navigation system.
2
Use the supplied screw to fasten the
connectors.
Install the GPS antenna
You can install the signal receptor of GPS
antenna:
On the dashboard cover
On the back panel of rear-view mirror
12
EN
b
Note
Make sure that the contact surface that contacts with
the metal sheet is free of moisture, dust, grime, oil, and
any other dirt.
If you remove the metal sheet, some adhesive may be
left on the contact surface.
1
Remove the protective cover of the metal
sheet, and then affix it.
2
Affix the antenna box onto the metal
sheet.
3
Use clamps to secure the antenna cable.

Mount into the dashboard

Note
Make sure that wires are correctly connected before
you mount the main unit into a car.
If preset radio stations are lost when the ignition key
is turned OFF and then back ON, reconnect the red
leads crosswise to the yellow ones.
b
a
c

Advertisement

Table of Contents
loading

Table of Contents