Table of Contents
Advertisement
Mounting Bracket
Step8
Use impact drill (bit φ 8.0mm, length
20cm) to directly drill at the marking
positions of the hangers and the hole
depth should be about 7 cm.
3
5
Screw package：
Expansion tube (X 3)
Gasket (X 3)
Expansion screw (X 3)
Installation Of HV50056
Step9
Hang the HV50056 onto the rear bracket .
Wiring
Step10
Rotate the waterproof connector counterclockwise according to
1
the installation procedure to remove the plug.
Use a screwdriver to remove the maintenance cover before
2
doing wiring.
The battery has no air switch
3
protection. Please be careful not to
short the positive and negative poles
during installation.
4
Make sure the waterproof joint seal
is inserted into the plastic claw ring
during installation.
Note：Pack the PE bag on
the battery to prevent dust
before punching.
Advertisement
Table of Contents
