Table of Contents
Advertisement
Drilling Hole
Step4
Place the battery against the wall and confirm the location
A
of the battery with a horizontal ruler.
B
Please drill four holes (two by each side) directly on the
wall at the marking positions of the brackets with an impact
drill (bit φ 8.0mm, length 20cm) and the depth of each hole
should be about 7 cm.
Note：
1：Confirm installation space。
2：Pack the PE bag on the battery to block out the dust before drilling.
Mounting Fixed Panel
Step5
A
Insert the expansion tube into the drilled hole.
B
Insert the expansion screw through the gasket and
lock with a screwdriver.
C
M4856-S can be stacked with max. 4 batteries in each row.
To install additional battery repeat step 2 -4.
2
90cm
PE Protective bag ( X 1)
195cm
650cm
4
5
Screw package：
Expansion tube (X 4)
Expansion screw (X 4)
Gasket (X 4)
Advertisement
Table of Contents
