luminii Teava Suspension TEA-S Series Installation Instructions

Teava Suspension - Installation Instructions
Model: TEA-XX-S
Please read all instructions prior to installation and keep for future reference!
1. Product to be installed by a qualied electrician.
2. Prior to installation ensure power is off at fuse box to prevent electrical shock.
3. More than one person is recommended for this installation.
1
measure
1.1
fixture
support
over 72", comes
with support
Note:
Prior to installation all 24VDC wires must be present in
junction box. Refer to the power supply installation
instruction for additional information.
Note:
More than one person is recommended for this
installation.
1.1 Align one standoff hub to the junction box & measure the
distance from standoff hub to the other hub. Then mark this
location to the ceiling, if over 72" an additional support will be
included that would also need a mark. Also marks will be
necessary if using more than one fixture. Use canopy detail to
slighting off center standoff hub. If connecting multiple fixtures
together reference step 7.
3
junction box
3.2
24V DC- 24V DC+
strain
3.1
relief
coaxial
cable
Note:
Prior to wiring the desired fixture height must be
determined to cut off any un-necessary wire.
3.1 While one person is holding the fixture, the other person can
slide the coaxial cable end through the clear o-rings, thumb
nut, backplate & crossbar assembly.
3.2 Peel back the coaxial cable to expose the power wires. Connect
the red (24VDC+) & black (24VDC-) power supply wires to the
fixture red & black wires.
*LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATION & INSTRUCTION WITHOUT NOTICE
standoff
hub
canopy detail
1.1
standoff
cap
4-3/8"
7/8"
4-3/8"
crossbar
assembly
3.1
backplate
fixture
power wire
thumb nut
o-ring
2
2.2
hole
anchor
ceiling
standoff
location
marks
13/64"
drill bit
2.1
drill
2.1 On the marked location(s), make a hole using a 13/64" drill
bit.
2.2 Insert the anchor into the hole and push completely in.
2.3 Insert wood screw through cap & washer and then tighten to
secure into the anchors.
4
junction box
4.1
crossbar
#8-32 screw
backplate
4.1 Insert the wire nut connections into the junction box & align the
crossbar to the junction box holes and secure using the provided
two #8-32 screw.
4.2 Slide the backplate up to the crossbar and secure by hand
tightening the thumb nut into the crossbar.
7777 Merrimac Ave
Niles, IL 60714
T 224.333.6033
F 224.757.7557
E472444
info@luminii.com
Page 1 of 3
www.luminii.com
2.3
2.3
spacer
cap
wood screw
4.2
REV0.1