Installing An Sfp - Avaya Ethernet Switch 5000 Series Manual

Small form factor pluggable transceivers
1000BASE-XD
1000BASE-ZX
1000BASE-XD CWDM
1000BASE-ZX CWDM
1000BASE-BX (LC type)
1000BASE-EX
1000BASE-BX (LC type)
For more information about specifications for these SFPs, see
page 29.

Installing an SFP

Install an SFP to provide an interface between the switch and the network cable.
Installing an SFP takes about three minutes.
Prerequisites
• Verify that the SFP is the correct model for your network configuration.
• Before you install the optical connector, ensure it is clean.
Warning:
Risk of eye injury by laser
Fiber optic equipment can emit laser or infrared light that can injure your eyes. Never look
into an optical fiber or connector port. Always assume that fiber optic cables are connected
to a light source.
24 Installing Transceivers and Optical Components on Avaya Ethernet Switch 5000 Series
Model
AA1419051-E6
AA1419052-E6
AA1419053-E6 to
AA1419060-E6
AA1419061-E6 to
AA1419068-E6
AA1419069-E6,
AA1419070-E6
AA1419071-E6
AA1419076-E6,
AA1419077-E6
Comments? infodev@avaya.com
Product number Description
1550 nm, up to 40 km
1550 nm, up to 70 km
1470 nm to 1630 nm, up to 40
km
1470 nm to 1630 nm, up to 70
km
Bidirectional 1310 nm and
1490 nm, up to 10 km
The 1000BASE-BX SFPs
are paired devices—for more
information, see 1000BASE-
BX10 DDI SFP
specifications on page 45
1550 nm, up to 120 km
Bidirectional 1310 nm and
1490 nm, up to 40 km
The 1000BASE-BX SFPs
are paired devices—for more
information, see 1000BASE-
BX40 DDI SFP
specifications on page 46.
SFP specifications
December 2013
on