Related Manuals for Wren Kitchens 150 Pull Out
Summary of Contents for Wren Kitchens 150 Pull Out
- Page 1 BASE UNIT 150 - 300 Pull Out Assembly Guide 150 Pull Out 300 Pull Out For Internal Use: FI.WR.INS.029_WKIN00101_BASE_PullOut_150-300_1Dr_Rev4.indd...
- Page 2 BASE UNIT BEFORE YOU START 150 - 300 Pull Out INSTALLATION SHOULD BE PERFORMED BY A Assembly Guide COMPETENT PERSON ONLY. THIS PRODUCT COULD BE DANGEROUS IF INCORRECTLY INSTALLED Panel A Panel B Panel C Legs Frontal x1Back Panel x2 End Panel x2 Base Fixed Panel (Packed separately) (M) x4...
- Page 3 BASE UNIT 150 - 300 Pull Out Step 1. Seat dowel (F) into Assembly Guide holes in both end Seat (G) panels (B) as shown. cam dowel into hole as shown. Step 2. Seat cam dowel (G) into holes in both end panels (B) as shown.
- Page 4 BASE UNIT 150 - 300 Pull Out Assembly Guide Step 5. Slide back panel (A) into groove of end panels (B). Once back panel (A) is in position, ensure the panel is flush & square with bottom of end panels (B). Step 6.
- Page 5 BASE UNIT Step 8. Secure each of the legs into 150 - 300 Pull Out place with 2 x 15mm screws Assembly Guide (L) per leg. Front Ensure legs are rotated as shown so that part of it is supporting the end panels (B). Front Front legs should have flat edge to the front.
- Page 6 Use 16mm screws. Step 1 of pull out Step 2 of pull out instructions instructions 150 Pull Out 300 Pull Out For Step 4 in pull out instructions. Use 19mm screws. Step 4 of pull out Step 4 of pull out...
- Page 7 BASE UNIT 150 - 300 Pull Out Assembly Guide Screw to Adjacent Unit Screw through side panels (B) where appropriate, into any side units, using the 30mm screws (K) provided to secure to unit. Place a cover cap (M) on the head to conceal it. L Brackets Where applicable, secure unit to the wall using 2 x 15mm screws (L) to secure each of the L brackets...