Cleaning And Maintenance - Lanaform NOSE SHAVER Instructions Manual

PARTS
EN
1. Adjustable guides (2; 4 ; 6; 8 mm and 10; 12; 14; 16 mm)
2. Head for shaving the beard and sideburns
1.
3. Blade protection support
2.
4. Pivoting blades of the razor
5. Head for shaving the nose and ears
3.
6. Receptacle for hairs
4.
7. Light
5.
6.
8. Ventilation screen
9. Switch
7.
8.
10. Battery cover
9.
11. Cleaning brush
12. Lubricating oil
10.
11. 12.
INSERTION/REPLACEMENT OF BATTERIES
Remove the battery cover (10) by turning it counterclockwise. Insert one AA battery (not included) into the
razor, making sure to match the poles. Re-close the battery compartment with the cover (10) by turning
it clockwise.
In order to respect environmental protection policies, we recommend that you do not dispose of a used
battery by throwing it away in a trash can in your home; instead, deposit it at a recycling center.
USAGE
Remove the blade protector.
Turn the switch to the Marche position (I)
Replacement of razor blades
The NOSE SHAVER comes with two shaving heads (2) and (5). To a x one of them, insert it in the groove
and turn it clockwise so that the round part of the shaver head is facing the round part of the receptacle
for hairs (6).
To remove one of the massage heads, turn it counterclockwise.
Use for the nose and ears
Gently insert the metallic part of the support (4) into the nose or ear to trim unwanted hair.
4
Use on the beard or sideburns
This support (2), designed to cut and smooth out the beard and sideburns, can be designed with the
adjustable guides (1). Choose the support that you would like and place it as shown in Figure C.
Adjustable supports for combs
The NOSE SHAVER comes with two adjustable guides (1) that allow you to choose from the following
lengths:
Short comb: 2 to 8 mm
Long comb: 10 to 16 mm
System for ventilation and hair collection
The NOSE SHAVER is equipped with a ventilation system that is active at all times during operation. The
trimmed hairs are automatically collected in the receptacle (6) Empty and replace the hair receptacle after
each trim.
Check that the ventilation screen (8) is not covered or obstructed during use.
Light
The NOSE SHAVER has a light (7) that allows for enhanced visibility of the areas you want to work on.

CLEANING AND MAINTENANCE

Important
A.
Ensure that the NOSE SHAVER is not on before cleaning the blades.
Do not submerge the NOSE SHAVER in water ( g. A). Only the set of blades and the
heads are washable in water.
B.
To remove the trimmed hair from the NOSE SHAVER, remove the head (5) or (2) by
turning it counterclockwise and remove the hair receptacle (6).
Clean the two parts with the brush provided for this purpose (11) or wash them
with water ( g. B).
C.
Ensure that the head or set of blades are completely dry before
remounting them. To dry them, use a soft rag.
Clean the blades of the beard head with the brush provided for this purpose. It is
also possible to clean the body of the apparatus with a soft rag. Never use abrasive
solvents or detergents.
EN
Nose Shaver
5