Installing The Service Access Cover - IBM Power System LC921 9006-12P Service Manual

Figure 77. Releasing and opening the cover
4. Lift up the front of the cover up and remove it from the system.
Installing the service access cover on an 9006-12P system
Learn how to install the service access cover on a rack-mounted IBM Power System LC921 (9006-12P)
system.
About this task
Attention: For safety, airflow purposes and thermal performance, the service access cover must
be installed and fully seated before you power on the system.
Procedure
1. Place the rear of the cover on the system. Pivot to front of the cover down until it rests on the system.
2. Slide the cover forwards until it latches into place as shown in Figure 78 on page 98.
Common procedures for servicing or installing features in the 9006-12P 97