Carrier i-Vu Open Link Installation And Startup Manual page 15

10 Click Enter to view the Router Configuration screen. See example below.
11 Type 3 to change the IP Address. Click Enter.
12 Type the new IP Address. Click Enter. This IP address will now show up on the Router Configuration
screen.
13 Type 4 to change the Subnet Mask. Click Enter.
14 Type the new Subnet Mask. Click Enter. This Subnet Mask will now show up on the Router Configuration
screen.
15 Type 5 to change the Default Gateway. Click Enter.
16 Type in the new Default Gateway. Click Enter. This Default Gateway will now show up on the Router
Configuration screen.
17 After entering your settings, type 1 to reset and click Enter.
18 Verify that you can communicate with the i-Vu Open Link by issuing a PING command to the IP address
specified in step 12.
NOTE Your PC must be on the same subnet as the Router for the PING command to work.
19 When finished, set the i-Vu Open Link's Router Config Mode DIP switch to OFF to restore normal
functionality to the Local Access port.
20 Cycle the i-Vu Open Link's power to accept the Router Config Mode changes.
i-Vu Open Link 11