Troubleshooting - RAYLASE MINISCAN II-07 Manual

11 TROUBLESHOOTING

11 TROUBLESHOOTING
The laser beam can cause severe injuries to the eyes and skin.
 During troubleshooting, never look directly or indirectly into the laser beam.
 Do not deactivate any safety precautions designed to protect against laser radiation.
 Wear laser protection clothing and/or goggles appropriate for the relevant danger rating.
1. Make sure that only the necessary professionals are in the room for troubleshooting and that they
have protective equipment appropriate to the hazards.
2. In case of malfunctions, check whether the problem and a possible remedy appear in the
following checklist.
3. If the fault cannot be resolved, contact RAYLASE Customer Service.
Problem
Processing quality is
poor
Processing quality has
deteriorated
Laser spot changed
No laser beam although
the laser process has
been started
Deflection unit only
deflects the laser beam
in one direction or not at
all
X and Y axis reversed
© 2017 RAYLASE GmbH MINISCAN II
WARNING
Possible cause Remedy
Electrical energy supply defective
Processing parameters incorrect
Deflection unit unsuitable for selected application
Lens dirty See page 26, Cleaning the lens
Mirror dirty See page 27, Cleaning the mirrors
Laser power reduced The RAYLASE laser processing software weldMARK
can be used to compensate for a deteriorating laser
power. Menu: System > Global Settings
Processing parameters changed
Beam expander changed
Lens dirty See page 26, Cleaning the lens
Mirror dirty or damaged Send deflection unit to RAYLASE for repair
Laser system badly adjusted
Beam path blocked Remove protective cover from beam input and/or output
Laser control defective
Laser system defective
Data line defective
Wiring incorrect
MN102-en / v1.0.3
F2 -010 .1
F 2-0 10.2
F2 -01 0.3
®
32