Setting Up Vlans - Avaya WLAN 8100 Series Quick Start Manual

1. Log into the controller. If this is the first time accessing the device, connect a console
2. Press CTRL + Y on the keyboard to enter the CLI.
3. Enter Privileged mode using the enable command.
4. Enter General Configuration mode using the configure terminal command.
5. Specify the system IP address, subnet mask, and default gateway using the ip
6. Enable SNMP services using the command snmp-server enable.
7. Disable SNMP user lists using the command no ipmgr snmp.
8. Enable IP routing capabilities using the ip routing command.
9. Enter Wireless Configuration mode using the wireless command.
10. Specify the wireless IP address using the command interface-ip
11. Enable wireless capabilities using the enable command.
12. Enable MDC capability using the controller mdc-capable.
13. Enter the domain password at the prompt.

Setting up VLANs

This section contains information and procedures for initial VLAN set up.
Related topics:
Creating a VLAN
Deleting a VLAN
Configuring VLAN name
Enabling automatic PVID
Configuring VLAN port settings
Configuring VLAN members
Avaya WLAN 8100 Quick Start Guide
cable and start a terminal session using the guidelines provided in the
documentation.
address command. This command has the following syntax:
ip address <ip_address> netmask <subnet_mask> default-
gateway <default_gateway>
<ip_address> command.
on page 10
on page 10
on page 10
on page 11
on page 11
on page 11
Setting up VLANs
August 20, 2010 9