Activation Of Blower - Jacuzzi alimia Installation Manual Use & Maintenance

Pump 2
In some jets the water flow can be adjusted via the intake out-
er ring nut.
• Amount of air in the hydromassage
The intensity of the hyrdomassage is determined by the amount
of air introduced into the water, regulated by means of control
knobs on the edge of the spa.
- To obtain the maximum amount of air, turn each knob clock-
wise; turn counter-clockwise to reduce the amount of air.
C
• Amount of water in the hydromassage
Some hydromassage intakes are connected to each other by
means of a diverter.
D1
D1
D1
- You can use the diverter to adjust the flow of water to a set of
nozzles, with respect to the other set, in inverse proportion. That
is, by turning the knob one way or the other, the force of the jets
will increase in one set of nozzles and decrease in the other.
CAUTION
Do not adjust the diverter(s) when the pump is
running.
I
ACTIVATION OF BLOWER (air compressor)
The spa is provided with air jets located in nozzles positioned
as illustrated in previously.
The system conveys the air to the jets, thus forming bubbles,
which travel up through the water and expand until they reach
the surface where they burst, also creating a pleasant visual
effect.
Press the "Blower"
The blower can be activated either in conjunction with, or
separately from, the hydromassage pumps. When the system is
started, however, the blower is always off, as are the hydro-
massage pumps.
The blower stays on for 20 minutes. It can be shut off before
that by pressing the key again.
If you want to use the blowers for aroma therapy, insert the
perfume cartridge in the compartment located under the cover
(see the chapter "Aromatherapy".
35
D2
D1
D2 D2
D1
D2
key to start the air compressor.