Advertisement
WARNING
To reduce the risk of serious bodily injury from fluid injection
or splashing in the eyes or on the skin, stop using the nozzle
immediately if it starts to leak or cannot be turned easily.
Installing the Tip and Guard (Fig. 1 and
Fig. 2)
ti2505a
Fig. 1
1.
Without the spray tip installed, start sprayer, turn the
knob on the CleanShot Shut–Off Valve counter–clock-
wise to the FLUSH position. (Fig. 2)
2.
Flush and prime the spray system.
3.
Follow the Pressure Relief Procedure described on the
front cover of this manual.
4.
Install the spray tip.
5.
Turn the knob on the CleanShot Shut–Off Valve to
SPRAY. (Fig. 2)
6.
Rotate the CleanShot Shut–Off Valve to any desired
position within 180_. Do not use any tools.
7.
Refer to your separate gun instruction manual for oper-
ating and tip cleaning instructions.
8.
This adapter is repairable.
INSTALLATION
To avoid damage to the o–ring in the swivel:
D Relieve fluid pressure before rotating the swivel.
D Do not soak the entire swivel in solvent.
Flush and Spray
Fig. 2
The
CleanShot Shut–Off Valve provides two settings: SPRAY
and FLUSH. The valve is factory set to the SPRAY position for
spraying at pressures above 700 psi (4.8 MPa, 48 bar). Turn the
valve (override) to the FLUSH position for flushing, cleaning,
priming and relieving pressure. FLUSH is also used for low
pressure spraying applications below 1000 psi (6.9 MPa, 69
bar).
180_
CAUTION
309642
3
Advertisement
