Troubleshooting
Problem & Possible Solutions
Sound is weak:
Increase the volume
Replace the empty battery
Clean or exchange the ear piece
Hearing aid emits whistling sounds:
Reinsert the ear piece until it fits securely
Decrease the volume
Clean or exchange the ear piece
Sound is distorted:
Decrease the volume
Replace the empty battery
Clean or exchange the ear piece
Hearing instrument emits spontaneous signal tones:
Replace the empty battery
Hearing aid does not work:
Turn the hearing aid on
Gently close the battery compartment completely
Replace the empty battery
Make sure the battery is inserted correctly
Power-on-delay is active. Wait several seconds and check again
Consult your Hearing Care Professional if you have further problems.
Adore
MB PB Quick Start Guide
™
This is not a substitution for reading your Owner's Manual. For more In depth
instructions, please refer to your Owner's Manual.
1. Insert Batteries In Your Hearing Aids
• Open the battery compartment
• Insert a new battery
• "+" side facing up (flat side)
• Make sure the battery "+" and compartment "+" match
13
2. Turn Your Hearing Aids On
• Close the battery door
• Your hearing aids may turn on immediately or your
Hearing Professional may have programmed a 6,12,
or 18 second start-up delay
No Delay
6 Second
3. Insert Your Hearing Aids
A: Hold the tube close to the ear piece.
- Carefully push the ear piece into the ear canal.
- Twist it slightly until it sits well.
- Open and close your mouth to avoid accumulation
of air in the ear canal.
- Lift the hearing instrument and slide it over the
top of your ear.
RX 18814 Rev. 1018 Part # 10240527/2.0
12 Second
18 Second
Need help?
Do you have a question about the Adore MB PB and is the answer not in the manual?
Questions and answers