Non-Printing Area - Sharp DX-B352P Manual

Note: • The printer tray is designed with the "paper type dial" for commonly used paper
size, which can be adjusted as required. When the paper type used for printing
is different from that the dial sets, the LCD display of the printer will show
"Optional tray I, PaperSize Mismat." indicating an error, then it is necessary to
reset the dial to eliminate the error.
• For those paper types that are not shown on the dial, please set up the paper
size through the control panel.
4. Raise the output tray to avoid the printed paper from slipping and falling.
Note: • If the paper loaded into the optional tray at one time exceed 550 pages
(21 lb. bond), paper will jam or cannot be fed in.
• If printing only the single side, please make the side to be printed (the blank
side) down.
• For installation of the optional tray, please refer to the Installation Guide
attached with the optional tray.

2.3. Non-printing Area

The shaded section indicates the non-printing area.
Usage
Print
Note: •The above margin settings only correspond to PCL6.
Top and Bottom
Paper Size
Margins (A)
A4
5 mm (0.197 in)
Letter 5 mm (0.197 in)
Left and Right
Margins (B)
5 mm (0.197 in)
5 mm (0.197 in)
12