Install Cylinder Shields; Install Intake Manifold And Carburetor Assembly - Briggs & Stratton 405777 Series Manual

3. Install valve covers with new gaskets, Fig. 18.
a. Torque screws to 100 in. lbs. (11.0 Nm).

INSTALL CYLINDER SHIELDS

1. Install No. 1 cylinder shield and fuel pump assembly,
Fig. 19.
a. Torque 1/4-20 screw to 80 in. lbs. (7.0 Nm)
b. Assemble solenoid harness ground wire to #10-24
screw and torque to 45 in. lbs. (5.0 Nm).
2. Install No. 2 cylinder shield.
a. Torque 1/4-20 screw to 80 in. lbs. (7.0 Nm).
b. Torque #10-24 screw to 45 in. lbs. (5.0 Nm).
INSTALL GOVERNOR CONTROL BRACKET
1. Install governor control bracket and assemble governor
lever to governor shaft, Fig. 20. DO NOT tighten nut at
this time.
a. Torque control bracket screws to 80 in. lbs. (7.0
Nm).
INSTALL INTAKE MANIFOLD AND CARBURE-
TOR ASSEMBLY
1. Install intake manifold and carburetor assembly, using
new gaskets, Fig. 21.
a. Torque screws to 80 in. lbs. (9.0 Nm).
b. Assemble governor link to governor lever.
c. Connect solenoid wire to solenoid.
d. Connect breather tube to air horn.
Note: Route armature ground wire between breather
tube and air horn.
6
TSM
Fig. 18 − Install Valve Covers
1/4-20
SCREW
Fig. 19 − Install Cylinder Shields
TORQUE TO 80IN.
LBS. (6.8NM)
DO NOT
TIGHTEN
NUT
Fig. 20 − Install Governor Control Bracket
C
Fig. 21 − Install Intake Manifold And Carburetor
#10-24
SCREW
A
B