Adjust Governor; Armature - Briggs & Stratton 405777 Series Manual

4. Install intake manifold and carburetor assembly, using
new gaskets, Fig. 30.
a. Assemble governor link to governor lever.
b. Torque screws to 80 in. lbs. (9.0 Nm).
c. Connect solenoid wire to solenoid.
d. Connect breather tube to air horn.
Note: Route armature ground wire between breather
tube and air horn.
5. Assemble blower housing to engine.
a. Torque screws to 80 in. lbs. (9.0 Nm).
6. Install rotating screen.
a. Torque screws to 20 in. lbs. (2.0 Nm).
Assemble air cleaner and install spark plugs.

ADJUST GOVERNOR

WARNING: BEFORE STARTING or running en-
gine, static adjustment of the governor must be
completed! Failure to make the static adjustments
first could result in engine overspeeding which
may result in engine damage, property damage or
personal injury.
Static Governor Adjustment
1. Rotate governor control swivel counter-clockwise as far
as it will go (wide open throttle) and hold in this position.
2. Rotate governor shaft clockwise as far it will go.
a. Torque governor nut to 130 in. lbs. (15.0 Nm).
Install throttle and choke control cables and check for
proper operation.
Install exhaust manifold.
b. Torque screws to 140 in. lbs. (16.0 Nm).
Note: Exhaust manifold and exhaust system sup-
plied by equipment manufacturer.
10
TSM
B
A
Fig. 30 − Install Intake Manifold And Carburetor
Fig. 31 − Install Blower Housing
CONTROL
SWIVEL
GOVERNOR
SHAFT
Fig. 32 −Adjust Governor
C