Setting The Clock - Philips AJ3915/05 User Manual

Clock
1 Insert the battery into the battery
compartment for clock memory backup.
2 Connect the power plug to the wall outlet.
Replace the battery once a year, or as often
•
as necessary.
Batteries contain chemical substances, so
they should be disposed of properly.

Setting the clock

The clock uses 24-hour time format.You may
set the clock from 0:00 if the set is
disconnected from the wall outlet.
1 Press and hold CLOCK until clock digit for
hour flashes.
➜ It will exit the clock setting mode without
setting if there is 5-second inactivity.
2 Press repeatedly, or hold down ∞ / § to
adjust the hours.
3 Press CLOCK to confirm the hour setting.
➜ The clock digits for minute flash.
4 Press repeatedly, or hold down ∞ / § to
adjust the minutes.
5 Press CLOCK to confirm the setting.
Radio
1 Press POWER to switch on from standby.
➜ The display lights up.
2 Select RADIO source by pushing
CD•RADIO•BUZZER to RADIO
(located on the side panel).
➜ "TUNER" is displayed.
3 Push BAND to FM or MW to select
desired waveband.
4 Turn TUNING to find your station.
5 To adjust the sound, turn VOLUME.
6 To view radio information, press DISPLAY.
➜ The current waveband and frequency will
be displayed for several seconds (See 2),
then it will switch back to clock display.
7 To switch off radio and back to standby, press
POWER.
➜ The display lights off.
Radio
To improve reception:
FM: Extend and adjust the pigtail for optimum
reception.
MW: Uses a built-in antenna. Direct the
antenna by adjusting the position of
your unit.
This set complies with the radio
interference requirements of the
European Community.
CD playback
This CD clock radio can play only audio discs
including CD-R (CD-recordable), CD-RW
(CD-rewritable).
MP3-CD, CD-ROM, CD-RW, CDI,VCD, DVD
or computer CD.
1 Press POWER to switch on from standby.
➜ The display lights up.
2 Select CD source by pushing
CD•RADIO•BUZZER to CD.
➜ "CD" is displayed.
3 Lift the CD door to open.
4 Insert a CD with printed side facing up, and
close the CD door.
➜ Flashing ---- is displayed briefly, then total
CD track number.
5 Press ); to start playback.
6 To view CD track information, press
DISPLAY.
➜ The current track number is displayed for
several seconds (See 3), then it will
switch back to clock display.
7 To adjust the sound, turn VOLUME.
8 To interrupt, press );.To resume playback,
press ); again.
9 To stop playback, press 9.
10 To switch off CD playback and back
to standby, press POWER.
➜ The display lights off.
CD Player
Do not try to play a