Troubleshooting; Disposal Of Your Old Product; Environmental Information - Philips AJ3915/05 User Manual

Troubleshooting

If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or
service center.
WARNING:
stances should you try to repair the set yourself, as this will invalidate the warranty.
No sound.
– Volume not adjusted.
• Adjust the VOLUME.
CD playback does not work.
– CD badly scratched or dirty.
• Replace/ clean CD.
– Laser lens steamed up.
• Wait until lens has adjusted to room temperature
– Laser lens dirty.
• Clean lens by playing a CD lens cleaning disc.
– CD-R is non-finalized.
• Use a finalized CD-R.
Occasional crackling sound during FM
broadcast.
– Weak signal.
• Extend the pigtail antenna fully.

Disposal of your old product

Your product is designed and manufactured with high quality materials and components,
which can be recycled and reused.
When this crossed-out wheeled bin symbol is attached to a product it means the
product is covered by the European Directive 2002/96/EC.
Please inform yourself about the local separate collection system for electrical and
electronic products.
Please act according to your local rules and do not dispose of your old products with your normal
household waste.The correct disposal of your old product will help prevent potential negative
consequences for the environment and human health.

Environmental information

All necessary packing material has been omitted to make the packing easy to separate into
2 categones: cardboard and paper pulp.
Your unit consists of materials which can be recycled if disassembled by a specialized
company. Please observe local regulations on the disposal of packing materials and old
equipment.
Do not open the set as there is a risk of electric shock. Under no circum-
Continuous crackling/ hiss disturbance
during MW broadcast.
– Electrical interference from TVs, computers,
fluorescent lamps, etc.
• Move set away from other electrical equipment
The alarm does not function.
– Alarm time not set.
• See section on Setting alarm time.
– Alarm mode not selected.
• See section on Setting alarm mode.
– No CD is inserted as CD is selected as Alarm
mode.
• Insert a CD.