Advertisement
SETTING THE CLOCK
1. Pull out PULL-TIME SET and turn it to set the clock. Always push PULL-
TIME SET back after setting the clock.
2. To read the time in the dark, press REPEAT ALARM -
up as long as REPEAT ALARM -
RADIO OPERATION
1 Press RADIO ON/OFF to switch on the radio.
2 Adjust the BAND switch to select your waveband.
3 Use TUNING to find your radio station.
To improve reception:
For FM , extend and position the coil antenna fully to obtain optimum reception.
For AM (MW or LW) , the set is provided with a built-in aerial. Direct the aerial by
adjusting the position of your clock radio.
4 Adjust the sound using VOLUME.
5 Press RADIO ON/OFF to switch off the radio.
USING THE ALARM
1 Set the RADIO•ALARM•BUZZ switch (at the bottom) to RADIO or BUZZ.
™ Important! If you want the radio alarm to wake you up, FIRST CHECK if you
have tuned to a station and adjusted the volume loud enough.
2 Turn ALARM 2 ring anti-clockwise to set the alarm time (one click of the dial is 10
minutes.)
3 Slide ALARM OFF/ON to switch on the alarm.
™ The alarm indicator
is pressed.
LIGHT
is shown on the top
. The clock lights
LIGHT
Advertisement
