Setting Up A Dual Clock Signals - HP 81110A Quick Start Manual

5. Setting Up a Dual Clock Signals

NOTE:
Here a Dual Clock Signal will be set up. In pattern mode with NRZ
(Non Return to Zero) pulses, a period of 12.5 ns and a high level of
2.50 V and a low of 0 V. Output 1 generates a clock signal that is half of
the system clock. Output 2 divides the system clock by 8.
Figure 47
NOTE:
1 Before setting up the signal it is recommended to reset all parameters
by pressing
HP 81110/04A Quick Start
For this example two Outputs are required.
Dual Clock Signal Diagram
With an additional dual channel instrument, multiples of these
dual clock signals can be set up following a similar procedure as
follows. For example, with 8 dual channel units up to 16 different
clocks can be generated.
Getting Started
Getting Started
Examples
.
97