HP 81110A Quick Start Manual page 91

4 Press the
channels. Change
level to
Figure 44
5 Press the
frequency of
delay to displace the pulse as required.
Output 2 has additional 2.5 ns delay in channel addition mode. Also,
the typical tranisiton times are 5 ns. So, enter transistions of 5 ns for
Output 1 to achieve same transition time shape in the added signal.
NOTE:
Figure 45
HP 81110/04A Quick Start
softkey to enter the Levels menu. Switch
|LEVELS|
Separate Outputs
and low level to
1.00 V
Current LEVELS Screen
softkey to enter the Timing menu. Enter a
|TIMING|
and a delay of
30 MHz
The in the width entry fields relate to the NRZ data output
'-------'
format selection.
Current TIMING Screen
Getting Started
to
Added at Output 1
for both outputs.
0.0 mV
for Output 2. Vary output 2
10 ns
Getting Started
Examples
both
ON
. Set high
93