Overprogramming; Display Modes - HP 81110A Quick Start Manual

Overprogramming

With
ter ranges to utilize the instrument to its limits.
NOTE:

Display Modes

In the following figure the results of pressing a softkey are displayed. In
this case it is possible to toggle between textual and graphical screens.
The toggle mode is available for the
TERN|
waveform display by pressing the softkey as required.
Figure 9
HP 81110/04A Quick Start
+
Proper operation of the instrument outside of the specified ranges
is not guaranteed. It is recommended to have the outputs switched
on when overprogramming, to have the internal error check sytem
activated, which warnsyou about impossible settings.
softkeys. It is possible to alternate between a textual display and
Toggling Display Mode
Introduction
Quick Access of Menus and Parameters
it is possible to exceed specified parame-
,
|TIMING| |LEVELS|
Introduction
and
|PAT-
41