Slide The System Into The Cabinet; Connect The I/O Cables And Power Cords - Dell EMC Integrated Data Protection Appliance DP4400 Service Manual

Hide thumbs Also See for EMC Integrated Data Protection Appliance DP4400:

Table of Contents

Remove and replace assemblies

Slide the system into the cabinet

Dell EMC Integrated Data Protection Appliance DP4400 2.4 Service Procedures Guide

Figure 49 Install System cover

Procedure

1. At the front of the cabinet, push the system inward until the lock levers click

into place.

2. Push the blue slide release lock tabs forward on both rails and slide the system

into the cabinet. The slam latches will engage to secure the system in the

cabinet.

Figure 50 Slide the system into the cabinet

This procedure is used to connect the peripherals and power to the system.

Procedure

1. Using the connection information recorded on the labels, connect the I/O

cables to the system.

2. Plug the power cords into the power supplies.

Table of Contents

Show Quick Links

Table of Contents

Do you have a question about the EMC Integrated Data Protection Appliance DP4400 and is the answer not in the manual?