Summary of Contents for Eaton PanelMate Power Series
Page 1
PanelMate Power Series Product Data 9” Monitor Cooling Fan Installation Introduction This document describes the installation of a cooling fan in the Cutler-Hammer 9” monitor. Description The Cutler-Hammer 9" color monitor is adequately ventilated and does not require forced air cooling to meet the specified life expectancy. Actual MTBF failure rates are better than the quoted rates.
Page 2
Remove the Cover Remove the six #6-32 screws that hold the monitor cover in place; two on each side of the chassis and two on the top of the chassis. Lift the cover straight up and clear of the monitor chassis. Remove the Video Cable Remove the six #6-32 screws that hold the base plate into the bottom of the monitor;...
Page 3
Install the Fan The position of the fan assembly is very important so as not to interfere with the existing cabling or the CRT. Place the monitor cover (1) top down with the sides standing vertically to the right and left of the installer.
Page 4
Reinstall the Monitor Set the monitor into the mounted frame of the PanelMate unit. Turn the two thumb nuts on the rear of the monitor 1/4 turn clockwise (until it clicks) to lock the monitor into place. Plug the monitor's video cable into the processor unit. Re-connect the AC power to the unit.