RTS ICW-6 Quick Start Manual

Quick Start Guide for ICW-6 Window Intercom

Packing list

Please inspect package contents

Included Parts

A. Cordset - European
B. Cordset - U.S.A.
C. ICW-6 Final Assembly
1. Operator-Side Assembly
2. Customer-Side Assembly
D. Switching Power Supply
E. Installation Kit
• #6 screws 1" (3)
• #6 washers (3)
• Cable Tie
F. User Manual (not shown)
G. Mounting Template (not shown)
H. Quick Start Guide (not shown)
I. Warranty (not shown)

Recommended Tools

• No. 1 Phillips screwdriver
• Equipment for cutting/drilling hole(s) for mounting
• 1" wide transparent tape
F.01U.196.220 Rev 03 12/2012

Installation

To install the ICW-6 window intercom, do the following:
1. On the operator unit, remove the two (2) side screws
holding the mounting plate to the operator assembly.
NOTE: To adjust the mic sensitivity, see "Inside Mic
Sensitivity Adjustment" on page 2
2. Measure and identify the location where the intercom is
to be mounted.
3. Attach the mounting template (included in box - P/N
LIT000401000) to the window (customer unit side)
being sure to center the appropriate guide in the location
identified.
4. Cut and/or drill the holes from the customer unit side.
5. Have an assistant place the customer unit against the
window. Make sure the holes line up correctly.
6. Attach the mounting plate removed from the operator
assembly using the three (3) supplied mounting screws
and rubber washers.
CAUTION: Do not allow
the intercom to hang from
the ground wire. The wire
connection may break.
7. Remove the lower left screw and washer and attach the
ground wire.

Copyright Bosch Security Systems 2012
NOTICE
USE THE POWER SUPPLY INCLUDED WITH THE ICW-6.
USE OF ANY OTHER POWER SUPPLY COULD DAMAGE
THE ICW-6 AND WILL VOID THE WARRANTY.
.
8. Attach the cable harness from the customer unit to the
connector on the operator unit.
9. Attach the operator unit to the mounting plate using
the side screws.
10. Screw the threaded end of the ICW-6 power supply
interface cord into the ICW-6.
The connector is located on the bottom of the ICW-6 on
the operator unit.
11. Secure the cord to the glass using wide clear adhesive.
12. Connect the power supply to AC power using the
supplied power cord.
Printed in USA