Scanstrut ROKK Bezel Installation Manual

I MP ORTAN T SA FE TY INS TR UCTI ON S
The product must be installed in accordance with the instructions provided. Failure to do so
could result in personal injury, damage to your vessel and/or product failure.
Scanstrut recommends a professional builder/installer to install the product. No liability is accepted for damage
and/or injury caused by incorrect installation.
WA RNI N G
• This product is designed to be fitted to a 12/24V DC power source only.
• This product may contain high voltages. Do not tamper with the product.
• The power supply must be switched off before installing the product.
• An appropriately selected fuse or circuit breaker must be used in line between the battery and the product
• This product is NOT approved for use in hazardous/flammable atmospheres. Do NOT install in a hazardous/
flammable atmosphere (Such as engine room of near fuel tanks).
• To ensure proper heat dissipation of the product, ensure it is being fitted with adequate space for proper
ventilation.
CAUTION
• The product has been designed specifically for the charging of Qi compatible devices.
• The cable must be adequately retained.
• This product contains no user serviceable components. Do NOT attempt to repair or
alter the product in any way.
• The high friction top surface does not ensure the device will not slip during extreme operating environments
such as high acceleration and deceleration.
• If a phone case which is thicker than 3mm is used it may cause either the device to not charge at all or the
product to temporarily shut down, this is a safety feature which protects the electronics from over-heating.
• When used in a high ambient temperature the product may temporarily shut down, this is a safety feature
which protects the electronics from over-heating. This safety feature may also be seen on the phone where it
will stop accepting charge.
• The IP rating is only valid if installed onto specified surfaces and closely following the installation instructions.
17/08/18 Is sue 1
REA D TH ES E I NS T RUC TI ON S BE FORE
INS TALL I NG THE P ROD UC T
IM PORTAN T S AF E T Y IN S T RUC T I ON S