Husqvarna 545RX Workshop Manual page 8

1
6
Starter
Tighten the return spring.
Check the spring tension.
Press the air guide plate on to the starter
housing.
Mount the starter onto the engine.
502 50 18-01
Replacing the drive dogs
See chapter 2, Electrical system.
Tighten the return spring.
Lift up the starter cord when the return
spring is completely loose and the cord
pulled out completely.
Then turn the starter pulley anticlockwise
7 revolutions.
Check the spring tension. With the cord
completely pulled out the cord pulley
should be able to be turned at least an-
other half revolution.
Press the air guide plate on to the starter
housing.
Mount the starter onto the engine.
Pull out the starter cord a little.
Place the starter in position and release
the starter cord at the same time.
Check that the drive dogs grip the starter
pulley in the correct way.
Tighten the bolts.
Replacing the drive dogs
See chapter 2, Electrical system.