Husqvarna 545RX Workshop Manual page 7

Starter
Remove the spring cassette.
!
Assembly
Clean requisite parts and assemble in the
reverse order as set out for dismantling.
NOTE!
Be careful when opening the packaging with the return spring so that the
spring does not fl y out.
Attach the spring cassette.
Attach the starter pulley.
Attach the new starter cord.
502 50 18-01
NOTE!
New starter cords can be attached without dismantling the starter!
Anchor the cord in the starter handle.
Remove the two bolts holding the spring
cassette and remove the cassette for
replacement if necessary.
WARNING!
Wear protective glasses. The return spring can
fl y out and cause personal injury if improperly
handled.
Assembly
Clean all components before assembly:
Change return springs, starter pulley and
starter cord as needed.
Attach the spring cassette and tighten the
two bolts (A).
Lubricate the bearing journal with a little
grease and attach the starter pulley.
Place the washer in place and tighten the
bolt.
Attach the new starter cord. Push it in to
the starter pulley's track as illustrated and
then out through the cord guide in the
starter cover. Make sure that the knot at
the end of the cord is as small as possible!
Thread the cord through the starter handle
and anchor it with a knot.
Fold down the free end and pull the knot
well into the handle.
1
5