Husqvarna 545RX Workshop Manual page 41

Angle gear
Remove the lubricant top-up plug.
Warm the gearbox and knock it against a
wooden block so that the input axle falls
out.
Remove the output axle.
502 50 65-01
503 97 64-01
Remove the lubricant top-up plug and
warm the entire gearbox using a hot air
gun to about 150°C.
Knock the gearbox against a wooden
block so that the input axle and bearing
fall out.
NOTE!
The input axle with pinion must be
dismantled fi rst.
Then remove the output axle and bear-
ings, while the gearbox is still warm.
Use puller no. 502 50 65-01.
Assembly
Replace damaged parts.
Assemble the angle gear in the reverse
order as set out for dismantling.
Fit the bearings on their respective axles.
It is easier if the bearings are heated to
approx. 100°C.
NOTE!
Do not forget the circlip holding the
bearing on the input axle. Make sure
the bearings bottom in their seats.
Heat the gearbox to approx. 150°C and
fi rst lift the output axle in position and then
the input axle. Make sure the bearings
bottom in their seats.
Mount the circlips and make sure they lie
correctly in their grooves.
Rotate the axles and check that they
rotate easily without a tendency for the
cogwheels to seize.
Fill the gearbox with special grease no.
503 97 64-01. Wipe any excess grease
from the joint between the shaft and the
angle gear before the gear is fi tted to pre-
vent it from turning around the shaft.
5
39