Husqvarna 545RX Workshop Manual page 57

Crankshaft and crankcase
Placera vevaxeln, överströmningska-
nalernas ledskena samt packningen på
kopplingssidans vevhushalva.
Put the crankcase half of the magnet side
in place and tighten the 5 screws.
Fit the sealing rings.
505 38 17-09
Fit the crankshaft and the guide rail for
the bypass channels to the clutch side of
the crankcase half.
Put the crankcase gasket in place and
make sure that both guide pins are in
position.
Slide the crankcase half of the magnet
side into place over the crankshaft.
Tighten the 5 crankcase screws crosswise
(1-5).
Check that the crankshaft can rotate
easily. If not, hit the axle spindles sharply
a few times with a rubber hammer so that
the tension in the crankshaft disappears.
Lubricate the axle spindles with engine oil
and press the sealing rings until level with
the crankcase using a suitable punch or
tool 505 38 17-09.
The metal covers of the sealing rings
should face outwards!
Fit the piston and cylinder and the remain-
ing parts in the reverse order as set out for
dismantling. See the respective sections
for detailed information if necessary.
7
55